Customer Center
Login | Register

FLEXMAP 3D® Instrument Support Videos

General Routines

System Initialization Routine

Learn how to run the system initialization routine on the FLEXMAP 3D® to prepare the instrument for use.

 

Standards & Controls

Learn how to add standards & controls to a protocol using xPONENT® 4.2 for FLEXMAP 3D.
 

 

Create a Batch from Existing Protocols

Learn how to create a batch from an existing protocol using xPONENT 4.2 for FLEXMAP 3D.
 

Probe Height Adjustment

Learn how to use the probe height adjustment tool for 384-Well Plates on the FLEXMAP 3D.

Shutdown the Analyzer

Learn how to shutdown the analyzer for FLEXMAP 3D software for up to a week in order to clean and flush fluidics.

Maintenance

Following the Maintenance Schedule

Watch this video to learn about following the maintenance schedule for FLEXMAP 3D.

 

Clean the Sample Probe

Here is a video to learn how to clean the sample probe for FLEXMAP 3D.
 

 

Replacing the Teflon Syringe Seal

Learn how to replace the Teflon Syringe Seal on the FLEXMAP 3D.
 

Replacing the HEPA Filter

Watch this video to learn how to replace the HEPA Filter on the FLEXMAP 3D.
 

Replacing the Sheath Fluid Filter

Watch this video to learn how to replace the Sheath Fluid Filter on the FLEXMAP 3D.

Replacing the Fuses

Learn how to replace the fuses on the FLEXMAP 3D.
 

Removing and Replacing the Ventilation Filters

This video will show you how to remove and replace the ventilation filters on the FLEXMAP 3D.

Troubleshooting

Run a Clog Removal Routine

Watch this video to learn how to run a clog removal routine with xPONENT for FLEXMAP 3D Software Version 4.2